Installation Tips

REASONABLE EXPECTATION:
It is our goal to provide the highest quality products.  The color and characteristic of the product images shown in our website are as accurately as possible. However, due to the inherent nature of the photographic and computer monitor viewing process, there may be some variation in the colors or contrast of the actual product from what appears on the your screen. All sizes and dimensions listed in are nominal.  
All Motor Graphics is not responsible for product failure due to improper installation, normal wear, or damage. Graphics are a wear item, and replacement will be required after a period or use. Some trimming may be required due to inherent differences in non-OEM plastics.

TEST FIT PARTS (DRY FITTING)
All items should be inspected for defects or damage and "dry fitted" prior to being installed. Installation instructions provided should be followed completely. We recommend that all items be professionally installed. Any concern or question as to fit or installation should be brought to our attention. We provide technical support during our normal business hours to help with installations. All reasonable attempts should be made for proper installation before making a return claim. It is our sole discretion to authorize returns for credit or exchange. 

WET INSTALLATION METHOD:
Clean the surface completely with a solvent such as Methyl Ethyl Ketone (MEK), or contact cleaner
   to remove various silicon deposits and allow for maximum adhesion.
Leave no residue or oils. The surface must be clean. If there are any deep scratches with burs that
   extrude from the surface, try scrapping them as flush as possible with a sharp razor blade.
Using a spray bottle, add 2-3 drops of liquid soap to 16 ounces of water.
Spray this solution onto the surface and then onto the adhesive side of the graphic.
Place the wet/adhesive side of the graphic onto the surface lightly to allow the graphic to float into place.
Using a plastic squeegee or similar tool work the solution from between the graphic and the surface.
Take extra care to push all of the water out while leaving no bubbles.
Use a hot hair dryer in the problem area to heat up the decal and make it more pliable and easier to manipulate
Allow the graphic to stand for 24 hours before riding.

DRY INSTALLATION METHOD:
Clean the surface completely with a solvent such as Methyl Ethyl Ketone (MEK), or contact cleaner
   to remove various silicon deposits and allow for maximum adhesion.
Leave no residue or oils. The surface must be clean. If there are any deep scratches with burs that
   extrude from the surface, try scrapping them as flush as possible with a sharp razor blade.
Trim the backing paper around the perimeter of the graphic.
Trial fit the graphic on the area that is to be applied. Make note of holes and curves and align accordingly.
Begin by peeling the backing paper away from the top of the graphic. Peel approx. 1″ and then check the
   graphics alignment. Fold the backing paper as needed and apply graphic to your desired starting point.
Once you have proper alignment, begin peeling the backing paper away while working the graphic
   onto the surface. You can use a small squeegee “if available” or your fingers to accomplish this.
   Watch for bubbles or wrinkles! Pull the graphic back slowly and reapply the problem area.
Repeat as needed until the graphic is placed in the desired location.

Would you like to show off your Awesome Looking Machines for the World to See?
Please email your pictures to sales@allmotorgraphics.com
If you have any questions feel free to contact us at 951-200-4507

×
×